Air and gas float traps DN15-20 FA16SS

The FA16SS is a very compact, small and lightweight float condensate remover specially designed for condensate drainage in compressed air lines and other compatible gases (Natural Gas, CO2, industrial gases, etc...) compatible with the materials of manufacture. Application in dryers, coolers, receivers, low points of line and other components in gas lines. Female threaded connections and vertical mounting.

  • Corrosion resistant
  • Replaceable internals
  • Modulating discharge
  • Unaffected by pressure changes or increases in purge flow rate.
  • Compression fitting.
  • Manual purge knob

  • Compressed air and non-corrosive gases compatible with construction.

  • FA16SS - stainless steel.

  • 1/2" y 3/4".

     

  • ISO 7 Rp or NPT female thread.
  • Vertical inlet 1/2" or 3/4" (top to bottom).
  • Vertical outlet 1/2

  • Vertical installation. It must be installed absolutely vertical in the points of the installation where the condensate 
  • installation where condensate tends to accumulate.
  • The drain must be channeled to a safe position.