Electric Condensate Recovery Unit ECRUV
ADCAMat ECRUV series electric condensate recovery units are recommended in the transfer of high temperature water, such as hot condensate, to a higher elevation or pressure. This condensate is often used as boiler feedwater. Standard models are rated for flow rates up to 4 m³/h.
The units consist of a vertical condensate receiver (receiver), a metal support frame, electric pump, level controls, valves, pre-wired control panel and piping for connections between the various elements of the units
- Condensate vessel – Completely manufactured from carbon steel or AISI 316 stainless steel, with inlet connections, overflow, air vents, drain, pump feeding outlets and a set of conductive level switches.
- Metal frame – Manufactured from structural steel (sandblasted and painted) or stainless steel (sandblasted).
- Pump – Manufactured from stainless steel, capable of handling hot condensate up to 98 ºC and designed for low NPSH.
- Control panel – Metal enclose ure rated to IP 65 or higher. Features pump fault indication, level alarms, operating mode selector switch and volt-free telemetry terminals for remote stats. The unit requires a 3 phase, 380-415 V AC, 50 Hz power supply
- Thermal insulated vessel.
- Full or partial stainless steel construction.
- Different pumping capacities.
- Alternative designs.
- ECV150 2T10 - 150L tank capacity, 2 m³/h flow rate and 10 m delivery head.
- ECV225 4T10 - Tank capacity 225L, flow rate 4 m³/h and 10 m discharge head.
Others upon request.
- The condensate is brought into the vessel through the inlet connections, with stainless steel sparge pipes, located on the top of the vessel. As the condensate level rises it will trigger the level control system to start the pumping process.