Sanitary pressure sustaining valves PS163

The ADCAPure PS163 is a series of direct acting in-line diaphragm pressure sustaining valves. These regulators, available with spring or dome loading, are designed for use with clean steam, compressed air, water and other gases or liquids compatible with the valve's materials of construction and design. 

  • Spring-loaded or dome-loaded.
  • Non-rising adjustment knob.
  • Compact in-line design with clamped body.
  • FDA / USP Class VI compliant seals.
  • Fully machined from bar stock, no castings or forgings are used. 

STANDARD SURFACE FINISH 

  • Internal wetted parts: ≤ 0.51 micron Ra - SF1.
  • Outer: ≤ 0.76 micron Ra - SF3.
  • For other surface conditions, see IS PV20.00 E - Technical information.
  • Ultrasonic cleaning
  • Leakage line connection.
  • Dome loading.
  • Top cap (adjusting screw with cover).
  • Pressure gauge connection on body.
  • Bottom cap with drain connection.
  • Different soft seals for liquids and gases.
  • Degreasing for oxygen application

  • Clean steam, compressed air, water and other gases and liquids compatible with the construction.

  • PS163

  • 1/2" to 2"; DN 15 to 50

  • 0,8 to 1,5 bar; 1 to 3 bar; 1,5 to 8 bar.

  • ASME BPE Clamp, DIN and ISO or pipe welding ends (ETO). 
  • Others on request.

  • Horizontal installation. 
  • See IMI - Installation and maintenance instructions

  • Assembly and packaging in a clean room certified according to ISO 14644-1. The product is covered and sealed with recyclable heat-shrinkable plastic film to avoid contamination.