Separador centrífugo de humedad para vapor limpio S11
Clean Steam Centrifugal Separator
(Inline connections)
When wet steam is used in sterilization, moisture reduces the efficiency of heat transfer and therefore the validity of the sterilization process can be compromised.
The S11 series separators remove moisture from the steam lines in the supply to consumers. Steam passes through the separator and as a result of expansion, impact and the effects of centrifugal force, particles with a heavier specific gravity are separated and fall out, such as water droplets and suspended moisture.
The condensate collected at the bottom of the separator must be drained automatically by a suitable drainer.
- 316L stainless steel construction.
- No moving parts.
- Self-draining design.
STANDARD SURFACE FINISH
- Wetted parts: ≤ 0,51micron Ra - SF1.
- Exterior: ≤ 0,76 micron Ra - SF3.
- Other surface finishes see IS PV20.00 E - Technical information.
- Ultrasonic cleaning
- Vent connection.
- Different kinds of connections and dimensions.
Steam, compressed air and other gases (Group 2).
- S11.
- S11A – with air vent connection.
- 1/2”, 3/4”,1”, 11/2” and 2”.
- Clamped ends ASME BPE.
- Other sanitary clamp or tube weld connections available on request.
- Always with the condensate discharge pointing downwards. See IMI, installation and maintenance instructions.
HOW TO SELECT
- Generally, in an existing plant it is advisable to fit a separator with the same size of the pipe line. Pressure drop is normally negligible. For approximate pressure drop calculation please consult.
- Assembling and packaging in a clean room certified according to ISO 14644-1.
- The product is end capped and sealed with recyclable thermo-shrinkable plastic film, to avoid contamination.